To obtain warranty service, call 1-80. Behr Process Corporation reserves the right to inspect any and all application of the product prior to processing your claim made under this warranty. Note to residents of the State of New Jersey: The provisions of this warranty, including its limitations, are intended to apply to the fullest extent permitted by the laws of the State of New Jersey. This warranty gives you specific legal rights and you may also have other rights, which vary from state to state. This warranty excludes (1) labor and costs of labor for the application or removal of any product, and (2) any incidental or consequential damages, whether based on breach of express or implied warranty, negligence, strict liability or any other legal theory. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. If this product is found not to perform as specified on the label during the warranty period, Behr Process Corporation will, at its option and upon presentation of proof-of-purchase (the original receipt), either furnish an equivalent amount of new product or refund the original purchase price of this product to you. Color fading and chalking will occur naturally over time. THIS WARRANTY IS NOT VALID WHEN THE PRODUCT IS NOT PROPERLY APPLIED TO A PROPERLY PREPARED, PREVIOUSLY UNCOATED AND PREVIOUSLY UNTREATED VERTICAL SURFACE OR CARED FOR IN ACCORDANCE WITH THE LABEL DIRECTIONS. Follow all preparation instructions under “New or Unpainted Surfaces” above.īehr Process Corporation warrants to you, the original consumer purchaser, the performance of this product as described on this label for 10 years on vertical surfaces, from the date of purchase. For Interior or Exterior application remove deteriorated coating prior to application. If the existing paint is removed, the loose paint should be removed down to a sound substrate by wire brushing or sanding. Sanding, grinding or abrading may release sanding dust, which may be harmful if inhaled and has been shown to cause lung damage or cancer with long term exposure. Avoid contact with skin and eyes and avoid breathing vapors, spray mist and sanding dust. If the tape does not pull the paint from the surface, it can be painted. MAY CONTAIN: CRYSTALLINE SILICA AND TITANIUM DIOXIDE. Test for loose, flaking paint by pressing a piece of masking or cellophane tape at various places, then pull it off with an abrupt action. 875, HOWEVER, BEHR WILL NOT GUARANTEE THE RESULTS. PREVIOUSLY PAINTED SURFACES IN GOOD, REPAINTABLE CONDITION MAY BE PAINTED WITH BEHR PREMIUM NO. 875 provides best results when applied to bare or untreated surfaces. Previously Painted Surfaces: BEHR DryPlus No.All surfaces must be clean and free of dirt, dust, efflorescence and oil. For above grade application: Remove mildew stains with a mildew stain removing product.For below grade application: All holes or cracks must be properly patched with a fast setting hydraulic cement.If the existing concrete is removed, the loose concrete should be removed down to a sound substrate. If the tape does not pull the concrete from the surface, it can be painted. Test for loose, flaking concrete by pressing a piece of masking or cellophane tape at various places, then pull it off with an abrupt action. New or Unpainted Surfaces: New concrete must cure for a minimum of 30 days.
0 Comments
Leave a Reply. |